Perform DPF Regeneration on a 2018 Foton Aumark using the LAUNCH X431 PAD V. This procedure effectively clears soot from the diesel particulate filter through a high-temperature burn. Follow the structured steps below to ensure a successful diagnostic operation.
Pre-Test Conditions
Before starting the process with X431 PAD 5, ensure the following initial conditions are met:
- Engine Status: The engine must be running at idle.
- Vehicle Position: The vehicle must be completely stopped.
- Operational Safety: Do not depress the accelerator, clutch, or brake pedals, and ensure the transmission is not in gear.
Diagnostic Navigation Path
Navigate the LAUNCH X431 PAD V software using this specific sequence:
- Select Local Diagnose >> Foton >> Vehicle Type >> Conventional Energy >> M4 (Light Truck) >> Auto Scan >> Smart Detection >> System List >>
- Enter the Engine module and confirm with OK.
- Select Actuation Test >> Aftertreatment Diesel Particulate Filter Regeneration.
Execution Steps
- Read the on-screen prompts and press OK to proceed.
- Select Yes to enter the graphical data interface for real-time monitoring.
- Once the test conditions are confirmed, click Start.
- Wait for the program to run; the X431 PAD V will notify you when the operation is completed.
Safety Termination Protocols
The test will automatically stop if a fault becomes active or if any pedals (accelerator, clutch, or brake) are depressed. You may also press the Stop button to end the test manually at any time.
Visited 11 times, 11 visit(s) today