LAUNCH Creader Elite 2.0 BMW Benz VAG Scanner FAQs

LAUNCH Creader Elite 2.0 BMW Benz VAG Scanner FAQs

Here we list some frequently asked questions and answers related to LAUNCH Creader Elite 2.0 BBA Multilingual Scanner. Hope this is helpful.

LAUNCH Creader Elite 2.0 BMW Benz VAG Scanner FAQs

 

Q1: System halts when reading data stream. What is the reason?

It may be caused by a slackened connector. Please turn Creader Elite 2.0 off, firmly connect the connector, and switch it on again.

LAUNCH Creader Elite 2.0 BMW Benz VAG Scanner FAQs

 

Q2: Screen of the tool flashes at engine ignition start?

Caused by electromagnetic disturbing, and this is normal phenomenon.

 

Q3: There is no response when communicating with on-board computer?

Please confirm the proper voltage of power supply and check if the throttle has been closed, the transmission is in the neutral position, and the water is in proper temperature.

 

Q4: What to do if the system fails to start auto VIN detection?

Please check the following possible reasons:

  • Whether the Creader Elite 2.0 is properly connected to the vehicle’s DLC port.
  • Whether the “Automatic detection on Connect” switch is OFF. If yes, slide it to ON.

LAUNCH Creader Elite 2.0 BMW Benz VAG Scanner FAQs

 

Q5: Why are there so many fault codes?

Usually, it’s caused by poor connection or fault circuit grounding.

 

Q6: How to upgrade the system?

  1. Switch the Creader Elite on and ensure a stable internet connection.
  2. Tap “Settings” on the Job Menu, select “About” -> “Version”, and tap “Detect the System Version” to enter the system upgrading page.
  3. Follow the on-screen instructions step by step to finish the process. It may take several minutes depending on the internet speed, please be patient. After upgrade is successfully finished, the Creader Elite tool will automatically restart and enters the Job menu.

 

www.x431shop.eu

Visited 5 times, 1 visit(s) today