This is a quick guide on how to do MAN clutch relearn gearbox match with LAUNCH X431 PAD5 Elite + SmartLink C 2.0 HD3.
Connect PAD V Elite to OBD port, waiting for the HD3 to start up.
Local Diagnosis >> Manufacturer >> Man(HD) >> OK >> Special Functions >> Clutch Relearn >> Clutch >> Calibration >> New Clutch Retrofitted
User Instructions
The following prerequisites must be ensured during the actuator test:
Vehicle secured to prevent it from rolling away.
Gearbox in neutral
Engine running
Do not press the accelerator
Sufficient compressed air in the compressed-air tank
No entries present in the control unit diagnostic memory.
Press OK.
Please switch off the ignition.
Please wait 10s!
Please switch on the ignition.
Speed up clutch adaptation: Completed
Program clutch biting pint: Completed
Reset characteristic curve: Completed
New clutch fitted: Completed
Reset clutch load: Completed
Delete diagnostic memory: Completed
Routine completed successfully
Test Report
Start-up has successfully been completed.
Used clutch retrofitted >> OK
Please switch off the ignition.
Please wait 10s!
Please switch on the ignition.
Speed up clutch adaptation: Completed
Program clutch biting pint: Completed
Reset characteristic curve: Completed
Set intial clutch position completed
Reset clutch load: completed
Delete diagnostic memory: completed
Routine completed successfully
Test Report
Start-up has successfully been completed.
Select “Slope Sensor”.
User Instructions:
The following preconditions must be met: vehicle secured to prevent it from rolling away.
Gearbox in neutral
Engine stopped
Vehicle at driving height
Level surface
Press OK.
Calibration successful.
Value in control unit being updated
Please switch on the ignition.
Please wait 10s!
Inclination sensor calibration in progress: calibration successful
User information
The tilt sensor calibration process is complete.
Calibration inclination angle sensor
Calibration successful
Done.
