This is a tutorial on how to clone 6T45 BOSCH ECU with Launch X431 ECU & TCU Programmer on bench. You can also use the X431 X-PROG3 & PC Adaptor to do the job instead.
Procedure
Open X431 ECU & TCU Programmer software, search “6T45”.
Make: Chevrolet
Model: Cruze 2008-2019
Engine: 1800 140
ECU: 6T45
Select BENCH connection type.
Connect device, BOSCH module and PC according to “Direct connection of diagram”.
Click “Connect” after successful connection.
Read FLASH data.
After reading the original car ECU, disconnect it and replace it.
Click “Disconnect”.
Click “Connect” after connecting to the new ECU.
Read FLASH data.
Save the new data file.
Write FLASH data >> Selected the original data file
Writing FLASH data successfully.
Click “Disconnect” to exit.
Chevrolet Cruze 6T45 BOSCH ECU clone was done.